Fleetwood V8-368 6.0L VIN 9 FI (1982)
A.Flush Condenser (On Car) -
FIGURE 1 - CONDENSER FLUSHING
a.
Attach extension tubes to the condenser bottom (outlet) and top (inlet) fittings, see Figure 1. The tubes must extend above the condenser core
and drain into a suitable waste container.
b.
Force liquid R-11 into the condenser bottom (outlet) fitting extension tube until clean R-11 flows from the condenser top (inlet) fitting
extension tube, see Figure 1. Use the large orifice nozzle flush gun J-33883-50 or equivalent.
c.
Cap the tubes with air conditioning hose end caps or appropriate plugs. Wait a minimum of 5 minutes before removing caps and draining the
condenser.
d.
Force R-12 vapor into the condenser top (inlet) fitting extension tube to purge the remaining R-11, see Figure 1. Use the large orifice nozzle
flush gun J-33883-50 or equivalent. Continue to blow R-12 vapor until no liquid is observed leaving the condenser bottom (outlet) fitting
extension tube.
B.Flush Evaporator (On Car) -
FIGURE 2 - EVAPORATOR FLUSHING
a.
Attach extension tubes to the evaporator small opening (inlet) and large opening (outlet/suction side), see Figure 2. The tubes must
extend above the evaporator core and drain into a suitable waste container.