Fleetwood V8-368 6.0L VIN 9 FI (1982)
Oil Filter: Technical Service Bulletins
Engine - Proper 75 mm Oil Filter Installation
NO.: 90-I-51
DATE:
April, 1990
GROUP:
6A CORP. NO.: 906104R
SUBJECT:
PROPER INSTALLATION OF 75 MM OIL FILTERS
This installation information supersedes the 2/3 turn requirement specified on the oil, filter label, and in previous DSIB 90-I-12. Please discard DSE3
90-I-12.
To prevent leakage of the small 75 mm oil filters such as PF-40, PF-45, PF-47, PF-51, etc. it is very important that the installation instructions given
below are closely followed:
1.
Remove old oil filter and clean gasket sealing area on engine oil filter mounting surface.
2.
Lightly oil gasket with clean oil and install filter.
3.
After the oil filter gasket contacts the oil filter adapter base, "TIGHTEN 3/4 TO ONE FULL TURN". When necessary, use a cap-type wrench,
AC-Delco OF17W or equivalent, or a strap-type wrench to ensure proper installation.
4.
With engine oil at proper level, run engine and thoroughly check filter area for leaks.
IMPORTANT:
Be certain to follow replacement oil filter usage applications.
