Fleetwood V8-368 6.0L VIN 9 FI (1982)
FIGURE 7
3.
Setting The Idle Mixture Needles (If necessary from Step 2C above)
a.
Use tool J-29030-B, BT-76108, or equivalent, to turn both idle mixture needles clockwise until they are lightly seated, then turn each
mixture needle counterclockwise the number of turns specified in Figure 7.
b.
Reinstall carburetor on engine, using a new flange gasket if necessary. Do not install air cleaner yet.
4.
Readjusting Idle Air Bleed Valve (Only necessary if Step 3, above, was required)
a.
Start engine and run until fully warm, and repeat Step 2, above.
b.
If unable to set dwell to 25-35~, and dwell is below 25~, turn both mixture needles counterclockwise an additional turn. If dwell is above
35~, turn both mixture needles clockwise an additional turn. Readjust idle air bleed valve to obtain dwell.
5.
Seal the idle mixture needle openings in the throttle body, using silicone sealant (RTV). Sealing is required to discourage unnecessary adjustment
of the setting, and to prevent fuel vapor loss in that area as required for emission specifications.
6.
Perform idle speed adjustments if necessary.
