cadillac Workshop Repair Guides

Cadillac Workshop Service and Repair Manuals

All Technical Service Bulletins for Ignition Coil:|84526C|Page 1674 > < All Technical Service Bulletins for Ignition Coil:|84526C
Page 2
background image

If the Service Manual procedure does not correct the intermittent code 51 and if code 52 was not caused by a battery disconnect, repair the intermittent
code 51 and/or 52 as follows:

1.

Remove the distributor cap cover.

2.

Remove the four coil hold down screws and lift the coil out of the distributor cap.

3.

Locate the ground strap and verify that the hook is around a hold down screw.

4.

Replace the coil, positioning the ground eyelet around a hold down screw. Tighten securely.

If no trouble is found at the coil, other areas to check are:

1.

A loose ground wire at the three terminal connector to the distributor cap.

2.

The ground wires and connections in the harness to the distributor base.

Look for a pin not mating to the coil connections in the cap or a loose screw at the capacitor hold down in the distributor base (the ground is under the
capacitor bracket).
For warranty purposes, use labor Operation No. T6086 at .3 hours.

All Technical Service Bulletins for Ignition Coil:|84526C|Page 1674 > < All Technical Service Bulletins for Ignition Coil:|84526C