Fleetwood V8-368 6.0L VIN 9 FI (1982)
FIGURE 3CHECKING END PLAY MEASUREMENT
6.
Attach magnetic base (J-26900-13) to torque converter and set up dial indicator (J-8001) so that indicator tip is in center of tool wing nut (refer to
Figure 3).
7.
To make end play check, push upper knurled knob down, zero out dial indicator and pull lower knurled knob up. Be sure tapered plug stays seated
in converter hub. End play is the difference between up and down positions. DO NOT ALLOW WING NUT TO TURN WHEN MEASURING.
8.
Remove tool by holding upper knurled knob and turning wing nut counterclockwise until the collet can be removed from the torque converter
turbine hub.
Refer to the following chart for torque converter end play specifications. Torque converters that exceed the maximum end play specifications should be
replaced.
TRANSMISSION MODEL
CONVERTER TYPE
MAXIMUM END PLAY
THM 440-T4
TCC/VCC
0.50 mm
THM 125C
(0.019")
THM 200C THM 325-4L
TCC
0.60mm
THM 200-4R THM 350C
(0.023")
THM 200
THM 400
Open
1.30mm
THM 325
THM 425
(non-TCC)
(0.050")
THM 350