Fleetwood V8-368 6.0L VIN 9 FI (1982)
FIGURE 1
5.
Inspect the casting and fluid passages for foreign material that may have accumulated in pockets. Remove the foreign material with a small
screwdriver or an awl. (Refer to Figure 1).
6.
As necessary, repeat the washing and drying procedures as described in steps #3 and #4 until all foreign material is removed.
FIGURE 2
7.
While applying slight pressure with your finger against spring force in the control valve, remove the pin, sleeve or clip that retains the control
valve. (Refer to Figure 2).
FIGURE 3
8.
Slowly release pressure on the control valve and remove it from the body. A small flat blade screwdriver may be used to remove the bushing
from the bore. (Refer to Figure 3).
DO NOT USE EXCESS FORCE TO REMOVE VALVES OR BUSHINGS