Fleetwood Brougham V8-252 4.1L (1985)
3. Reseal rocker arm cover with gasket 1627340 or apply a continuous bead 3-4 mm in diameter of RTV sealant, such as 1052751 or equivalent, to
the sealing flange of the cover. DO NOT USE RTV ON GASKET.
4. Position cover to cylinder head and install screws. Do not slide cover around to align screws as sealing may be compromised. Try to lower cover
on to head in aligned position. Alignment dowels cut from 6 mm bolts will allow exact positioning. Torque to 5 Nm (4 if. lbs.).
5. Replace EGR gasket and install EGR valve and heat shield. Tighten screws to 25 Nm (20 ft. lbs.).
6. Install AIR management valve and tighten fasteners to 25 Nm (20 ft. lbs.).
7. Connect vacuum line from throttle body to vacuum pump.
8. Position spark plug wire retainers to cover mounting studs and connect wires to plugs. See: Tune-up and Engine Performance Checks/Firing
Order/Specifications
9. Clip wiring harness in place at EGR valve shield and solenoid bracket.
10. Loosen A/C hose retaining screw at rear of compressor and swivel hose back into position over cover. Retighten screw to 40 Nm (30 ft. lbs.).
11. Install air cleaner.