Fleetwood Brougham V8-252 4.1L (1985)
FIGURE 3 - MATCH MOUNTING THE WHEEL LOW POINT WITH THE TIRE HIGH POINT
Mount new tires aligning the yellow mark on the tire with the valve stem on the wheel (see Figure 3). Balance and install on non-drive axle positions.
Check alignment of non-drive axle and reset as necessary; see new alignment specifications in this bulletin. Both before and after alignment
measurements must be recorded on the R.O. Stress the importance of regular tire rotation and proper inflation pressures to the customer.
Revised Fleetwood Brougham Front Alignment Specifications
Toe:
Per Wheel .06~ +/- .05~
Sum
.12~ +/- .10~
Camber:
.25~ +/- .25~
Caster:
3.00~ +/- .50~
Revised Eldorado and Seville Rear Alignment Specifications
Toe:
Sum .10~ +/- .10~
For warranty purposes, use one of the following labor Operations:
FAILURE
LABOR
LABOR
NET
DESCRIPTION
CODE
OPERATION
HOURS
ITEM
^
Rotate tires using modified 06 T-6151 * -- X rotation (includes lock nuts) and align front or rear suspension
*
Fleetwood Brougham (front suspension) 1.4 Hrs.
Eldorado and Seville (rear suspension)
1.2 Hrs.
^
Mount and balance two tires 06 T-6150 ** *** (includes lock nuts) and align front or rear suspension
*
* Fleetwood Brougham (front suspension) 1.7 Hrs.
Eldorado and Seville (rear suspension)
1.5 Hrs.
Dealers are eligible for .2 administrative allowance as "other labor hours" if tires are replaced.
*
* * The Uniroyal tire invoice amount should be entered as a net item on the warranty claim.