Fleetwood FWD V8-300 4.9L (1993)
3.
Using bedding and glazing compound, run a 5 mm bead around the inboard edge of the retainer. Refer to Figure 6, Section A-A.
4.
Using bedding and glazing compound fill the two cavities in the upper rear corner of the door frame. Refer to Figure 6, View A.
5.
Spray window run channel with glass cleaner for ease of installation.
6.
Reinstall the window run channel using a flat-bladed tool to ensure that the run channel is fully seated in the retainer. Refer to Figure 6, View C.
Rear Door Window Area
X.
Wind noise at rear door window run channel to door frame.
1.
Lower the door glass.
2.
Remove the front, top, and rear portion of the run channel from the retainer from the door frame by pulling down and outboard on the run channel.
3.
Using bedding and lazing compound run a 5 mm bead a round entire inboard edge of the retainer. Refering to Figure 6, Section A-A.
4.
Using bedding and glazing compound fill the cavities in the bracket area of the front corner of the door header and at the top post. Refer to Figure
6, View B.
5.
Spray the window run channel with glass cleaner for ease of installation.
6.
Reinstall the window run channel a flat-bladed tool to ensure that the run channel is fully seated in the retainer. Refer to Figure 6, View C.
For warranty purposes use Labor Operation T1899 at .3 hour with .2 hour for each additional door.
Rear Door Stationary Glass Seal to Door Frame
XI.
Wind noise at rear door stationary glass seal to door frame.
