Fleetwood FWD V8-300 4.9L (1993)
Exhaust System Components
CATALYTIC CONVERTER
REMOVE OR DISCONNECT
1.
Raise vehicle and support catalytic converter.
2.
Cut intermediate pipe at the converter as shown in the figure. Cut as close to the weld as possible.
3.
Exhaust manifold rear pipe flange bolts / springs.
4.
Converter.
5.
Portions of the converter outlet remaining in the intermediate pipe.
INSTALL
1.
Converter. Position intermediate pipe for needed clearance during converter installation.
2.
Guillotine-type clamps.
TIGHTEN
^ Rear pipe flange bolts to 20 N-m (15 lbs. ft.).
^ Clamp nuts to 35 N-m (26 lbs. ft.).