Fleetwood FWD V8-300 4.9L (1993)
Wind noise due to a misaligned division post molding to upper scalp molding may be repaired by realigning the division post as shown in Figure 10.
a.
With the door trim and water deflector removed, loosen the upper and lower retaining screws and position as necessary. Reinstall the
water deflector and door trim.
Labor Operation:
T3352
Labor Time:
.4 hour per door
CAUTION:
APPROVED SAFETY GLASSES AND GLOVES SHOULD BE WORN WHEN PERFORMING THIS PROCEDURE TO REDUCE THE CHANCE
OF PERSONAL INJURY.
3.
Wind noise at rear door stationary glass seal to door frame.
a.
Remove the rear door stationary glass per Section 10-2-9 of the Service Information Manual.
