Seville V8-273 4.5L (1989)
![background image](/cadillac/seville/v8-273_4.5l/Page-1006.png)
When using a new terminal:
a.
Slip cable seal away from terminal (if seal exist).
b.
Cut wire as close to terminal as possible.
c.
Slip a new cable seal onto wire (if necessary).
d.
Strip 5mm (3/16") of insulation from wire.
e.
Crimp a new terminal to the wire.
f.
Solder with rosin core solder.
g.
Slide cable seal toward terminal (if equipped with a seal).
h.
Crimp cable seal and insulation (if equipped with a seal).
i.
Apply grease to connectors outside the passenger compartment where the connector originally was equipped with grease.
Figure 17
To re-use a terminal or lead assembly, see previous steps c through i for repairs. Be sure to keep cable seal (if equipped) on terminal side of splice.
5.
Insert lead from the back until it catches.
6.
Install TPA's, CPA's and/or secondary locks, if equipped (see Figures 18 & 19).
Figure 18
Figure 19