Seville V8-300 4.9L (1991)
PRESSURE BLEEDING
TOOL REQUIRED:
^
J 21472 Bleeder Wrench
^
J 28434 Bleeder Wrench
^
J 35589 Bleeder Adapter
^
J 29532 Diaphragm Type Brake Bleeder
NOTE: Pressure bleeding equipment must be of the diaphragm type. It must have a rubber diaphragm between the air supply and the brake fluid to
prevent air, moisture, oil and other contaminants from entering the hydraulic system.
1. Charge bleeder ball to 20-25 psi.
2. Connect line to adapter. Open line valve and depress bleed-off valve on top of adapter until a few drops of fluid appear.
3. Raise car.
4. Attach bleeder hose to bleeder valve and submerge opposite end in clean container partially filled with brake fluid.
5. Open bleeder valve 1/2 to 3/4 turn and allow fluid to flow until no air is seen in fluid.
6. Bleeding sequence:
A. Left front
B. Right front
C. Left rear
D. Right rear
