Seville V8-300 4.9L (1991)
Install a new case side cover pan which does not have the stamping "DO NOT PRY IN THIS AREA". The removal of this stamping has reduced the
raised edge and improved flatness on the sealing surface of the side pan. Even though the stamping "DO NOT PRY IN THIS AREA" has been removed,
it is NOT acceptable to pry in the described area to remove axle and/or seal. Refer to Figure 3.
IMPORTANT:
Do not exceed the recommended torque specifications for the pan nuts and bolts. Exceeding these specifications will contribute to further gasket splitting
and render any repair procedures useless.
The torque specifications for the F-7 and 4T60-E are as follows: