Seville V8-300 4.9L (1991)
2.
Relocate ground connection near starter (Figure 2) as follows:
a.
Remove the starter bracket mounting bolt to the block, the nut that secures the starter bracket to the starter, and the starter bracket.
b.
Discard the starter bracket and the starter bracket mounting bolt to the block.
c.
On DeVilles and Fleetwoods only, remove the ground cable located at the motor mount (G101).
d.
Clean both the ring terminal and the engine block in the area where the starter bracket was located with a wire brush.
e.
Using a new starter bracket, P/N 3538914, bend the starter bracket as necessary to provide clearance between the block and the bracket for
the ring terminal.
f.
Install the starter bracket with the ring terminal between the block and the bracket.
g.
Install a new starter bracket mounting stud to the block, P/N 3537885. Torque to 38 N-m (27 lbs.ft.).
h.
Reinstall the nut that secures the starter bracket to the starter. Torque to 3.0 N-m (27 lbs.in.).
3.
On 1991 and 1992 vehicles only, check the PCM PROM I.D. using on-board diagnostics. If the PROM I.D. in the vehicle is lower than the
indicated service PROM I.D. in the chart, replace the PROM with the indicated part number.
