Seville V8-300 4.9L (1991)
TIGHTEN
^
Rack and pinion attaching bolts to 68 Nm (50 lbs. ft.).
3. Return and pressure hose.
TIGHTEN
^
Hose fittings to 27 Nm (20 lbs. ft.).
4. Line retainer.
5. Raise frame and tighten body mount bolts.
6. Tie rod ends.
TIGHTEN
^
Tie rod end nut to 10 Nm (7.5 lbs. ft.) then an additional 1/3 turn (2 flats).
IMPORTANT
^
When tightening tie rod end nut, a minimum torque of 45 Nm (33 lbs. ft.) must be obtained. If 45 Nm (33 lbs. ft.) is not obtained, inspect for
stripped threads. If threads are satisfactory, replace tie rod end and knuckle.
^
After tightening castellated nut to specification, align slot in nut to cotter pin hole by tightening only. Do not loosen nut for cotter pin
installation.
7. Intermediate shaft coupling.
TIGHTEN
^
Intermediate shaft coupling bolt 50 Nm (30 lbs. ft.).
8. Pressure switch connector.
9. Heatshield.
10. Tire and wheel assemblies.
11. Lower vehicle.
12. Bleed power steering system.
INSPECT
^
Inspect for leaks.
