Seville STS V8-4.6L VIN 9 (1998)
Notice: Refer to Fastener Notice in Cautions and Notices. See: Restraint Systems/Air Bag Systems/Service and Repair/Fastener Precautions
2. Install the SISM mounting fasteners (1).
Tighten
Tighten fasteners to 9 N.m (80 lb in).
3. Install the SISM harness connector (2) to the SISM (1).
4. Install the Connector Position Assurance (CPA) (3) to the SISM harness (2) connector.
5. Install the center pillar trim. Refer to Garnish Molding Replacement - Center Pillar in Interior Trim.
6. Enable the SIR system. Refer to Enabling the SIR System. See: Body and Frame/Interior Moulding / Trim/Dash Board / Instrument Panel/Air
Bag(s) Arming and Disarming/Service and Repair/Air Bag Disarming and Arming/Enabling the SIR System
