Seville STS V8-4.6L VIN 9 (1998)
Turn Signal Switch: Service and Repair
Multifunction Turn Signal Lever Replacement
Removal Procedures
CAUTION: Before removing or installing any electrical unit or when a tool or equipment could easily come in contact with "live" exposed
electrical terminals, disconnect the negative battery cable to help prevent personal injury and/or damage to the vehicle or components. Unless
instructed otherwise, the ignition switch must be in the "OFF" or "LOCK" position.
1. Disconnect the negative battery cable.
2. Disable the SIR system. Refer to Disabling the SIR SYSTEM in RESTRAINTS.
3. Remove the steering wheel. Refer to STEERING WHEEL REPLACEMENT.
4. Remove the kneebolster. Refer to KNEE BOLSTER REPLACEMENT (LHD) in INSTRUMENT PANELS AND GAUGES.
5. Remove the two nuts (1) securing the steering column to the instrument panel.
6. Lower the column.
7. Remove the tilt lever handle.
8. Remove the upper and lower shrouds. Refer to SHROUDS, SHIFT LEVER SEAL.
9. Remove the two wire harness straps.
10. Remove one wire harness strap from the steering column tilt head assembly.
