SRX 2WD V8-4.6L VIN A (2004)
Trunk / Liftgate Shock / Support: Service and Repair
Strut Replacement - Liftgate
Strut Replacement - Liftgate
Removal Procedure
Caution: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the
vehicle or personal injury.
Notice: Apply pressure only at the end of the liftgate assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod
because damage or bending will result.
1. Open and support the liftgate.
2. Remove the tail lamp.
3. Using a small flat-bladed tool, release the clip retaining the liftgate assist rod to the lower assist rod ball stud.
4. Using a small flat-bladed tool, release the clip retaining the liftgate assist rod to the upper assist rod ball stud.
5. Remove the liftgate assist rod from the vehicle.
Installation Procedure