SRX 2WD V8-4.6L VIN A (2004)
Blower Motor Switch: Service and Repair
Blower Motor Switch Replacement Auxiliary (Front)
BLOWER MOTOR SWITCH REPLACEMENT AUXILIARY (FRONT)
REMOVAL PROCEDURE
IMPORTANT: Gently pull downward at the front edge of the overhead console to disengage the fasteners.
1. Remove the overhead console (1).
2. Disconnect the blower motor switch electrical connector.
3. Disconnect the dome lamp electrical connectors.
4. Remove the blower motor switch screws
5. Remove the blower motor switch from the dome lamp housing.
INSTALLATION PROCEDURE
1. Install the blower motor switch to the dome lamp housing.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the blower motor switch screws.
Tighten
Tighten the screws to 1 N.m (9 lb in).
3. Connect the blower motor switch electrical connector.