SRX 2WD V8-4.6L VIN A (2004)
6. Remove the suction hose retaining bolt from the compressor.
7. Remove the suction hose from the vehicle.
INSTALLATION PROCEDURE
1. Coat the new O-rings with refrigerant oil. Refer to O-ring Replacement.
2. Install the suction hose.
3. Connect the suction hose to the suction pipe.
4. Install the suction hose quick connect fitting.
5. Position the suction hose into the bracket.
NOTE: Refer to Fastener Notice in Service Precautions.
6. Install the suction hose retaining screw into the bracket.
Tighten
Tighten the screw to 2 N.m (18 lb in).
7. Connect the suction hose to the compressor.
8. Install the retaining bolt to the compressor.
Tighten
Tighten the bolt to 9 N.m (80 lb in).
9. Install the air cleaner assembly.
10. Evacuate and recharge the refrigerant system. Refer to Refrigerant Recovery and Recharging.
11. Leak test the fittings of the component using J 39400-A.
Suction Hose Replacement (With RPO Code C57)
