SRX 2WD V8-4.6L VIN A (2004)
Transmission Position Switch/Sensor: Service and Repair
Automatic Transmission - 5L50-E
Manual Shaft Shift Position Switch Replacement
^
Tools Required
-
J 44767 Seal Installer
Removal Procedure
1. Raise and support the vehicle.
2. Remove the transmission manual shift shaft nut.
3. Disconnect the shift linkage from the transmission manual shift shaft.
4. Remove the exhaust system.
5. Disconnect the propeller shaft coupler (1) from the transmission flange.
6. Push the front propeller shaft toward the rear of the vehicle in order to release the propeller shaft coupler (1) from the transmission flange.
7. Secure the front propeller shaft (1) to the shift control lever (3) with a piece of mechanics wire (2).
8. Important:
Replace the shaft seal only if leaking.
Using a small screwdriver, remove and discard the shaft seal.