SRX 2WD V8-4.6L VIN A (2004)
1. Clean any of the contamination from the male line ends and apply a few drops of clean engine oil.
2. With the aid of an assistant, carefully guide the chassis fuel hose/pipes up through the engine compartment into position.
3. Raise and support the vehicle. Refer to Vehicle Lifting.
4. Pull the right side transmission support down only enough to allow installation of the chassis fuel hose/pipes.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Install the bolts securing the transmission support to the underbody.
Tighten
Tighten the transmission support bolts to 60 N.m (44 lb ft).