SRX 2WD V8-4.6L VIN A (2004)
Electronic Brake Control Module: Service and Repair
Electronic Brake Control Module (EBCM) Replacement
Removal Procedure
1. Notice: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the
ON position.
Turn OFF the ignition.
2. Raise and support vehicle. Refer to Vehicle Lifting.
3. Remove the air deflector shield.
4. Remove the right front wheelhouse liner.
5. Important: It is not necessary to remove the washer solvent container from the vehicle.
Remove the washer solvent container bracket.
6. Important: The area around the Electronic Brake Control Module (EBCM) must be free from loose dirt to prevent contamination of dissembled
ABS components.
Thoroughly clean all of the contaminants from and around the EBCM assembly.
7. Notice: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the
ON position.
Press the retainer on the EBCM electrical connector (1).
8. Rotate the EBCM connector tab (2) forward to the unlocked position.
9. Disconnect the EBCM electrical connector (1) from the EBCM and position out of the way.
10. Remove and discard the 4 EBCM to Brake Pressure Modulator Valve (BPMV) screws (1).
