SRX 2WD V8-4.6L VIN A (2004)
1. Position the sensor to the vehicle.
2. Notice: Refer to Fastener Notice in Service Precautions.
Install the front ride sensor retaining nut.
Tighten the nut to 9 Nm (80 inch lbs.).
3. Connect the front ride sensor link to the upper control arm ball stud.
4. Connect the front ride sensor harness connector.
5. Install the tire and wheel.
6. Lower the vehicle.
Rear Position Sensor Replacement - Electronic Suspension
Rear Position Sensor Replacement - Electronic Suspension
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.
3. Disconnect the ride sensor link from the upper control arm ball stud.
4. Disconnect the ride sensor harness connector.