SRX 2WD V8-4.6L VIN A (2004)
14. Remove the lower control arm to knuckle mounting bolt.
15. Remove the adjustment link to knuckle mounting bolt.
16. Install J 45859 to the wheel bearing/hub.
17. Important: May need to use the wheel hub remover to fully disengage the wheel bearing/hub from the drive axle.
Using the J 45859 , disengage the wheel drive shaft from the wheel bearing/hub.
18. Remove the knuckle from the vehicle.
19. Remove the wheel bearing/hub bolts.
20. Remove the knuckle and backing plate from the wheel bearing/hub.
Installation Procedure