SRX 2WD V8-4.6L VIN A (2004)
7. Install the lower control arm to knuckle mounting bolt.
8. Connect the upper ball joint to the knuckle.
9. Install the upper ball joint mounting nut.
10. Install the parking brake cable bracket to the knuckle. Refer to Park Brake Cable Mounting Bracket Replacement in Park Brake.
11. Remove the jack.
12. Connect the ABS sensor electrical connector to the backing plate.
13. Connect the ABS sensor electrical connector.
14. Install a new wheel drive shaft nut.
Tighten the nut to 160 Nm (118 ft. lbs.).
15. Install the brake rotor. Refer to Brake Rotor Replacement - Rear in Disc Brakes.
16. Install the tire and wheel.
17. Lower the vehicle.