SRX 2WD V8-4.6L VIN A (2004)
Torque Converter: Service and Repair
Automatic Transmission - 5L40-E
Torque Converter Replacement
Removal Procedure
1. Remove the transmission from the vehicle.
2. Remove the torque converter from the transmission.
3. Remove the input shaft seal.
Installation Procedure
1. Important:
Take care to prevent cutting of the input shaft seal on the input shaft splines.
Install the input shaft seal.
2. Important:
Ensure the torque converter is fully seated into the transmission pump drive gear and turbine shaft.
Install the torque converter. Push the torque converter into position while rotating.
^
The torque converter must be fully seated on the turbine shaft
^
The torque converter must be fully seated in the pump drive gear
3. Install the transmission to the vehicle.