SRX 2WD V8-4.6L VIN A (2004)
Wiring Harness: Service and Repair
Automatic Transmission - 5L40-E
Transmission Internal Electrical Harness Replacement
Removal Procedure
1. Remove the Transmission fluid pan and filter.
2. Disconnect the transmission wiring harness connector (1) from the transmission by rotating the locking latch (2) counterclockwise.
3. Disconnect the internal wiring harness from components (1-8).
4. Remove the internal wiring harness retainer (2) from the internal wiring harness (1).
5. Remove the internal wiring harness (2) from the transmission.
6. Remove the O-ring seals (3) from the internal wiring harness (2) only if the O-rings are cut or worn.
Installation Procedure
