SRX 2WD V8-4.6L VIN A (2004)
Wiper Motor: Service and Repair
Wiper Motor Cover Replacement - Front
WIPER MOTOR COVER REPLACEMENT - FRONT
REMOVAL PROCEDURE
1. Remove the wiper motor module.
2. Remove the fasteners (2) from the wiper motor cover (3).
3. Carefully remove the wiper motor cover from the wiper motor housing (1).
INSTALLATION PROCEDURE
1. Ensure the wiper motor cover housing sealing surface is clean and dry.
2. Position the wiper motor cover (3) to the wiper motor housing.
IMPORTANT: To ensure proper wiper cover seal to wiper motor housing contact, the cover fasteners need to be equally tightened to the motor
housing.
3. Install the wiper motor cover fasteners (2).
NOTE: Refer to Fastener Notice in Service Precautions.
4. Tighten the fasteners in an "X", pattern as follows:
Tighten