SRX AWD V6-3.0L (2010)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
1. Ignition ON, observe the scan tool Driver Seat Heating/Venting/Cooling Mode parameter while pressing the driver HEATED seat switch. The
reading should change between Off and Back & Cushion.
‹› If not the specified value, replace the A20 radio/HVAC control.
2. Observe the scan tool Passenger Seat Heating/Venting/Cooling Mode parameter while pressing the passenger HEATED seat switch. The reading
should change between Off and Back & Cushion.
‹› If not the specified value, replace the A20 radio/HVAC control.
3. If all scan tool parameter readings test normal, there are no DTCs set, and the driver and/or passenger heated seat is inoperative, replace the K29
seat heating control module.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/Verification Tests and Procedures) after completing the diagnostic procedure.
*
Radio Control Assembly Replacement (See: Accessories and Optional Equipment/Radio, Stereo, and Compact Disc/Radio/Stereo/Service and
Repair/Radio Control Assembly Replacement)
*
Control Module References (See: Testing and Inspection/Programming and Relearning) for seat memory control module replacement, setup, and
programming