SRX AWD V6-3.0L (2010)
Note: Install new brake hose fitting gaskets.
3. Assemble the brake hose fitting bolt (1) and 2 new brake hose fitting gaskets (2) to the brake hose fitting (3).
4. Install the brake hose assembly to the brake caliper and tighten the fitting bolt to 40 Nm (30 lb ft).
5. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) (See: Brake Bleeding/Service and Repair)Hydraulic
Brake System Bleeding (Pressure) (See: Brake Bleeding/Service and Repair).
6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
Rear Brake Caliper Replacement
Rear Brake Caliper Replacement
Removal Procedure
Warning: Refer to Brake Dust Warning (See: Service Precautions/Technician Safety Information/Brake Dust Warning).
Warning: Refer to Brake Fluid Irritant Warning (See: Service Precautions/Technician Safety Information/Brake Fluid Irritant Warning).
1. Release the electronic park brake cable tension. Refer to Parking Brake Cable Adjuster Disabling (See: Parking Brake System/Parking Brake
Cable/Service and Repair/Procedures/Parking Brake Cable Adjuster Disabling).
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair
).