SRX AWD V6-3.0L (2010)
Special Tools
CH-37043 - Parking Brake Cable Release Tool
For equivalent regional tools, refer to Special Tools (See: Tools and Equipment).
Removal Procedure
Warning: Refer to Brake Dust Warning (See: Service Precautions/Technician Safety Information/Brake Dust Warning).
1. Disable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Disabling (See: Procedures/Parking Brake Cable Adjuster
Disabling).
2. Turn the ignition to the OFF position.
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
4. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair
).
5. Remove the parking brake shoes. Refer to Parking Brake Shoe Replacement (See: Parking Brake Shoe/Service and Repair).
6. Lower the rear suspension support approximately 152-254 mm (6-10 in). Refer to Rear Suspension Support Replacement (AWD) (See: Body and
Frame/Frame/Cross-Member/Rear Cross-Member/Service and Repair)Rear Suspension Support Replacement (FWD) (See: Body and
Frame/Frame/Cross-Member/Rear Cross-Member/Service and Repair).
7. Disconnect the right parking brake cable fitting from the parking brake intermediate cable connector.
8. Using the CH-37043 - Parking Brake Cable Release Tool , compress the locking tabs on the right parking brake cable conduit (1) and remove the
cable from the rear frame bracket.