SRX AWD V6-3.0L (2010)
5. Inspect the O-ring seals on the electronic parking brake control module spindle and the parking brake intermediate cable for damage and correct
positioning and replace, if necessary.
Note: Ensure the park brake intermediate cable fitting is engaged in the actuator in the spindle.
6. Install the parking brake intermediate cable fitting to the spindle.
Note: When installing the parking brake intermediate cable nut to the electronic park brake module spindle, hold the spindle housing securely to
avoid distorting the housing.
7. Install the parking brake intermediate cable nut (1) to the electronic parking brake control module spindle by rotating the nut clockwise and tighten
to 6 Nm (53 lb in).
8. Connect the electronic parking brake control module electrical connector.
9. Enable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Enabling (See: Parking Brake Cable/Service and
Repair/Procedures/Parking Brake Cable Adjuster Enabling).
10. Calibrate the electronic parking brake control module. Refer to Electronic Parking Brake Control Module Programming and Setup (See: Testing
and Inspection/Programming and Relearning/Electronic Parking Brake Control Module Programming and Setup).