SRX AWD V6-3.0L (2010)
7. Install the master cylinder (1) and the master cylinder O-ring seal (2). Refer to Master Cylinder Replacement (See: Hydraulic System/Brake
Master Cylinder/Service and Repair/Removal and Replacement).
8. Connect the brake fluid level indicator switch electrical connector.
Note: Install a new power vacuum brake booster pushrod retainer.
9. Install a new power vacuum brake booster pushrod retainer (1) to the power vacuum brake booster pushrod.
Note: Ensure the power vacuum brake booster pushrod retainer is fully engaged in the brake pedal arm.
10. Install the power vacuum brake booster pushrod and retainer to the brake pedal arm.
11. Connect the brake pedal position sensor electrical connector.
12. Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration (See: Accessories and Optional Equipment/Pedal
Positioning System/Pedal Positioning Sensor/Service and Repair/Brake Pedal Position Sensor Calibration).
13. Install the left side instrument panel insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side (See: Body and
Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel Insulator Panel Replacement - Left Side).