SRX AWD V6-3.0L (2010)
7. Install the master cylinder heat shield, if equipped.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
8. Install the master cylinder heat shield bolt (1) and tighten to 10 Nm (89 lb in).
Note: Lift the dash panel insulator slightly to remove the upper master cylinder heat shield nut.
9. Install the master cylinder heat shield nuts (1) and tighten to 25 Nm (18 lb ft).
10. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement (See: Engine, Cooling and Exhaust/Engine/Intake
Manifold/Service and Repair/Intake Manifold Cover Replacement).