SRX AWD V6-3.0L (2010)
Note: Lift the dash panel insulator slightly to install the upper master cylinder heat shield nut.
6. Install the master cylinder heat shield nuts (1) and tighten to 25 Nm (18 lb ft).
7. Install the radiator surge tank. Refer to Radiator Surge Tank Replacement (LF1) (See: Engine, Cooling and Exhaust/Cooling System/Coolant
Reservoir/Service and Repair/Radiator Surge Tank Replacement)Radiator Surge Tank Replacement (LAU) (See: Engine, Cooling and
Exhaust/Cooling System/Coolant Reservoir/Service and Repair/Radiator Surge Tank Replacement).
8. If installing a new EBCM, program the EBCM. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning).
9. Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle).
