SRX AWD V6-3.0L (2010)
3. Rotate the heater door gear clockwise (1) as far as it will go, and install the lever by engaging a gear tooth into the right most lever gap (2).
4. Install the mode cam into position on the levers.
5. Continue to push the mode cam onto the case and rotate left and/or right until an audible click is heard locking the mode cam in place.
6. Rotate the mode cam from stop to stop (1). It should rotate completely without binding. If the mode does not rotate from stop to stop, then remove
the mode came and levers and repeat steps 2-6.
7. Place the mode cam actuator and gear assembly (2) on the HVAC module and install the screws (1) and tighten to 1.7 Nm (5 lb in).
8. Connect the mode cam actuator electrical connector.
