SRX AWD V6-3.0L (2010)
6. Install the air conditioning condenser and evaporator hose (2) to the compressor.
7. Install the air conditioning condenser and evaporator hose bolt (1) at compressor and tighten to 15 Nm (11 lb in).
8. Connect the air conditioning pressure sensor electrical connector.
9. Install the front bumper fascia. Refer to Front Bumper Fascia Replacement (See: Body and Frame/Bumper/Front Bumper/Front Bumper Cover /
Fascia/Service and Repair/Front Bumper Fascia Replacement)
10. Lower the vehicle.
11. Evacuate and charge the A/C system. Refer to Refrigerant Recovery and Recharging (See: Heating and Air Conditioning/Service and
Repair/Procedures/Refrigerant Recovery and Recharging)