SRX AWD V6-3.0L (2010)
4. Compress the hose clamp and connect the power steering fluid cooler inlet hose to the power steering gear outlet pipe (3).
5. Compress the hose clamp and connect the power steering fluid cooler outlet hose (1) to the power steering fluid reservoir inlet pipe (2).
6. Connect the power steering fluid cooler inlet and outlet hose bracket to the body.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
7. Install the bolt (4) to the power steering fluid cooler inlet and outlet hose bracket and tighten to 9 Nm (80 lb in).
8. Install the front bumper fascia. Refer to Front Bumper Fascia Replacement (See: Body and Frame/Bumper/Front Bumper/Front Bumper Cover /
Fascia/Service and Repair/Front Bumper Fascia Replacement).
9. Install the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement (See: Body and Frame/Fender/Front Fender/Front Fender
Liner/Service and Repair).
10. Fill and bleed the power steering system. Refer to Power Steering System Bleeding (See: Steering and Suspension/Steering/Power
Steering/Power Steering Bleeding/Service and Repair).
11. Clean any excess power steering fluid from the vehicle.
12. Remove the drain pans.
