SRX AWD V6-3.0L (2010)
Wheel Speed Sensor: Service and Repair
Rear Wheel Speed Sensor Replacement
Rear Wheel Speed Sensor Replacement
Removal Procedure
Warning: Refer to Brake Dust Warning (See: Brakes and Traction Control/Service Precautions/Technician Safety Information/Brake Dust Warning)
.
Note: If replacing the wheel speed sensor due to a DTC, inspect the back of the wheel bearing on the encoder surface for metallic chips or metal
shavings. If metallic debris is found, clean the encoder surface to prevent interference with the wheel speed sensor signal and setting of a DTC. Refer to
Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System Check - Vehicle).
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair
).
3. Remove the rear suspension link. Refer to Rear Suspension Link Replacement - Upper to Lower Control Arm (See: Steering and
Suspension/Suspension/Service and Repair).
Note: Clean the wheel speed sensor mounting area on the suspension knuckle of any accumulated dirt and debris.
4. Remove the wheel speed sensor bolt (1).