SRX AWD V6-3.0L (2010)
6. Remove the nut (1) from underneath the protective boot behind the generator.
7. Remove the battery positive cable terminal from the generator.
8. Remove the starter solenoid nut (2) and battery positive cable terminal from the starter solenoid.
9. Remove the negative battery cable bolt (3) and terminal from the back of the left cylinder head.
10. Remove the harness retainer band clip nut (4).
11. Remove the harness retainer band clip bolt (5).
Note: Observe how the battery positive and negative cable was routed within the engine compartment.
12. Remove the battery positive and negative cable (6).
Installation Procedure
1. Install the retainers that hold the battery cable harness to the battery tray.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the battery cable harness to the engine block with retainer (4). Tighten to 9 Nm (80 lb in).
