SRX AWD V6-3.0L (2010)
350 in SI.
2. Inspect the terminals of these connectors for any corrosion, intermittent conditions and poor connections. Refer to testing for Intermittent
Conditions and Poor Connections in SI.
‹› If the terminals show any sign of corrosion, determine the source of the water leak. Repair the leak as necessary, Refer to > General
Information > Water Leaks > Diagnostic Information and Procedures in SI.
3. Replace the fuel tank harness to body harness pass-thru CONNECTOR with the new SEALED DESIGN CONNECTOR P/N 19178098.
4. Replace the connector terminals with terminals P/N 12047581 and P/N 12034047 found in the J 38125 Terminal Repair Kit. Refer to > Power and
Signal Distribution > Wiring Systems and Power Management > Diagnostic Information and Procedures in SI.
5. Inspect the mating fuel tank wiring harness connector terminals for any sign of corrosion.
‹› If the mating fuel tank wiring harness connector terminals show any sign of corrosion, replace the wiring harness.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the appropriate labor operation for the repair that was performed:.
Disclaimer