SRX AWD V6-3.0L (2010)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Using the CH 49375 - wrench , install front suspension strut mount washer (2) and the front suspension strut mount nut (1), then tighten the front
suspension strut mount nut to 50 Nm (37 lb ft).
3. Install the front suspension strut bolts (4) and the front suspension strut nuts (3).
4. Tighten the front suspension strut bolts to 190 Nm (140 lb ft)
5. Re-connect the electrical harness/sensor from the strut, if equipped.
6. Reconnect the head lamp level sensor link to the lower control arm, if equipped. Refer to Headlamp Leveling Front Suspension Height Sensor
Replacement (See: Lighting and Horns/Headlamp/Service and Repair/Removal and Replacement/Headlamp Leveling Front Suspension Height
Sensor Replacement).
7. Remove the support from the lower control arm and the steering knuckle.
8. Install the front stabilizer shaft link. Refer to Stabilizer Shaft Link Replacement (See: Stabilizer Bar/Stabilizer Link/Service and Repair/Front
Suspension).
9. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair).
10. Install the front compartment side sight shields. Refer to Front Compartment Side Sight Shield Replacement (See: Body and Frame/Doors, Hood
and Trunk/Doors/Front Door/Service and Repair).
11. Remove the support and lower the vehicle.