SRX AWD V6-3.0L (2010)
2. Hand start the transaxle mount bracket (2) to transfer case bolts.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the transfer case bracket bolts and tighten to 100 Nm (74 lb ft)
4. Install the transaxle mount the frame.
5. Install the longer transaxle mount to frame bolt (3) and tighten to 62 Nm (46 lb ft)
6. Install the shorter transaxle mount to frame bolts (4) and tighten to 100 Nm (74 lb ft)
7. Install the through bolt and tighten to 100 Nm (74 lb ft)
8. Remove the support from the transaxle.
9. Install the propeller shaft. Refer to Propeller Shaft Replacement (See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service
and Repair/Propeller Shaft Replacement)
10. If removed, install the right catalytic converter. Refer to Catalytic Converter Replacement - Right Side (LF1) (See: Engine, Cooling and
Exhaust/Exhaust System/Catalytic Converter/Service and Repair/Catalytic Converter Replacement - Right Side).
11. Lower the vehicle.