SRX AWD V6-3.6L (2008)
1. Position the trim panel (1) to the vehicle.
2. Position the seat belt over the top of the trim panel, ensuring that the buckle is not behind the trim panel.
3. Connect the electrical connectors.
4. Index the locating tabs on the trim panel to the holes in the body.
5. Seat the clips that retain the trim panel to the body.
6. Install the rear quarter trim cover to the rear quarter trim panel and push in to secure the retainers.
7. Install the rear compartment sill plate. Refer to Rear Compartment Sill Trim Plate Replacement (See: ) .
8. Install the body side rear upper garnish molding. Refer to Body Side Rear Upper Garnish Molding Replacement (w/TB5) (See: )Body Side Rear
Upper Garnish Molding Replacement (w/o TB5) (See: ) .
9. Install the side door garnish molding. Refer to Side Door Opening Frame Garnish Molding Replacement (See: ) .
10. Install the rear quarter trim tie down bezel (1).
11. Put the rear seats in the upright position.
Body Side Rear Upper Garnish Molding Replacement (w/o TB5)
Body Side Rear Upper Garnish Molding Replacement (w/o TB5)
Removal Procedure
1. Remove the seat belt retractor guide bolt (1).
