SRX AWD V6-3.6L (2008)
Seat Heater Control Module: Service and Repair
Front Seat Heater Control Module Replacement
Removal Procedure
Caution: Refer to SIR Caution (See: Restraint Systems/Service Precautions/Technician Safety Information/SIR Caution) .
1. Remove the front seat cushion. Refer to Front Seat Cushion Replacement (See: Seats/Seat Cushion/Service and Repair/Front Seat Cushion
Replacement) .
2. Disconnect the electrical connector from the heated seat module.
3. Remove the heated seat module screws (2) and remove the module.
Installation Procedure
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
1. Install the heated seat control module and install the retaining screws (2).
Tighten the screws to 2 N.m (18 lb in).
2. Connect the electrical connector.
3. Install the seat cushion. Refer to Front Seat Cushion Replacement (See: Seats/Seat Cushion/Service and Repair/Front Seat Cushion Replacement)
.