SRX AWD V6-3.6L (2008)
1. Install the bullet end of the sunshade cable to the end of the U-channel (3). The U-channel is located on the front of the track assembly (2).
2. Push the cable into the U-channel until the barrel end of the cable reaches 25 mm (1 in) from the end of the U-channel.
3. Use a flat-bladed tool (3) to push the cable (2) through the channel.
4. Push the cable until the cable barrel is approximately 32 mm (1.25 in) from the end of the sunroof track from the rear.
5. Install the sunshade stop set-screw (3) flush to the front edge of the U-channel.
Important: If the sunshade set screw is misadjusted or not installed in the track channel, the sunshade will not function properly. The
initialization process for the sunshade will not work.
