SRX AWD V6-3.6L (2008)
Sunroof / Moonroof Drain: Procedures
Sunroof Drain Inspection and Cleaning (Fixed Roof Window)
Sunroof Drain Inspection and Cleaning (Fixed Roof Window)
Inspection and Cleaning Procedure
Ultra View roofs have 1 drain, located under the roof side trim covers, in each rear body pillar.
1. Lower the rear headliner. Refer to Headlining Trim Panel Replacement (See: Interior Moulding / Trim/Headliner/Service and Repair) .
2. Remove the rear stationary window. Refer to Sunroof Window Replacement (Front) (See: Sunroof / Moonroof Panel/Service and Repair)Sunroof
Window Replacement (Rear Vent) (See: Sunroof / Moonroof Panel/Service and Repair)Sunroof Window Replacement (Center) (See: Sunroof /
Moonroof Panel/Service and Repair)Sunroof Window Replacement (Rear Stationary) (See: Sunroof / Moonroof Panel/Service and Repair) .
3. Pour a small amount of water into the sunroof module drain trough. Inspect for a plugged or disconnected drainage system. If the water flow is
restricted, perform the following steps:
Caution: Refer to Safety Glasses and Compressed Air Caution (See: Service Precautions/Technician Safety Information/Safety Glasses and
Compressed Air Warning) .
Important: Use care when using compressed air to clear the sunroof drain hose. Do not exceed 241 kPa (35 psi).
*
Use a flexible wire or 241 kPa (35 psi) of compressed air to clear any debris plugging the drain system.
*
Inspect the drainage system for proper water drainage.
*
If water drainage is still not adequate, remove the headliner. Inspect the sunroof drain hoses for proper routing. Refer to Headlining Trim Panel
Replacement (See: Interior Moulding / Trim/Headliner/Service and Repair) .
4. Install the rear stationary window. Refer to Sunroof Window Replacement (Front) (See: Sunroof / Moonroof Panel/Service and Repair)Sunroof
Window Replacement (Rear Vent) (See: Sunroof / Moonroof Panel/Service and Repair)Sunroof Window Replacement (Center) (See: Sunroof /
Moonroof Panel/Service and Repair)Sunroof Window Replacement (Rear Stationary) (See: Sunroof / Moonroof Panel/Service and Repair) .
5. Install the rear headliner. Refer to Headlining Trim Panel Replacement (See: Interior Moulding / Trim/Headliner/Service and Repair) .
Sunroof Drain Inspection and Cleaning (Rear Vent Window)
Sunroof Drain Inspection and Cleaning (Rear Vent Window)
Inspection and Cleaning Procedure
1. Move the rear window to the vent position.
2. Pour a small amount of water into the sunroof module drain trough. Inspect for a plugged or disconnected drainage system. If the water flow is
restricted, perform the following steps:
Caution: Refer to Safety Glasses and Compressed Air Caution (See: Service Precautions/Technician Safety Information/Safety Glasses and
Compressed Air Warning) .
Important: Use care when using compressed air to clear the sunroof drain hose. Do not exceed 241 kPa (35 psi).
*
Use a flexible wire or 241 kPa (35 psi) of compressed air to clear any material plugging the drain system.
*
Inspect the drainage system for proper water drainage.
*
If water drainage is still not adequate, remove the headliner. Inspect the sunroof drain hoses for proper routing. Refer to Headlining Trim Panel
Replacement (See: Interior Moulding / Trim/Headliner/Service and Repair) .
3. Install the rear headliner, if necessary. Refer to Headlining Trim Panel Replacement (See: Interior Moulding / Trim/Headliner/Service and Repair)
.