SRX AWD V6-3.6L (2008)
Drive Belt Tensioner: Service and Repair
Water Pump and Generator Belt Tensioner Replacement
Water Pump and Generator Belt Tensioner Replacement
Removal Procedure
1. Remove the generator and water pump drive belt. Refer to Water Pump and Generator Belt Replacement (See: Drive Belt/Service and
Repair/Water Pump and Generator Belt Replacement) .
2. Loosen the drive belt tensioner bolt.
3. Remove the drive belt tensioner and bolt from the engine.
Installation Procedure
1. Position the drive belt tensioner and bolt to the engine as an assembly.
2. Ensure that the alignment pin on the rear of the tensioner assembly is aligned with the locating hole on the engine.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
3. Install the drive belt tensioner bolt.
Tighten the drive belt tensioner bolt to 50 N.m (37 lb ft).
4. Install the generator and water pump drive belt. Refer to Water Pump and Generator Belt Replacement (See: Drive Belt/Service and Repair/Water
Pump and Generator Belt Replacement) .